6000 Series Vibratory Feeder Controllers

Model Selection

• Controller with Enclosure Model 6000

• Open Frame with Remote Pot Model 6005

• Open Frame Panel Mount Model 6006

• Open Frame Panel Mount Model 6045

• Vibratory Feeder Controllers with integrated sensor controls Model 6800

Features

UL Listed in US and Canada.

Offering you and your company the level of safety that is seen as the standard throughout The United States and Canada

Soft-Start Ramp-Up with Adjustment

This feature enables users to gently turn the feeder bowl or inline on gently. A ramped On-Cycle helps reduce parts from falling off of tooling when turned on. It also reduces damage by eliminating the jolt the vibratory units experiences each time the unit is turned on.

Minimum/Maximum Output Adjustment

Allows you to limit the minimum and maximum output of the main control potentiometer. By limiting the Full On output, operators cannot turn the feeder up too high or too low. This feature can prevent sheared tooling, spring cracks and damage to the armature and coil caused by "Coil Rap".

Run Interlock Output

The controller can by turned on and off through several inputs:

• a 5 - 30Volt DC or 105 - 250 Volt AC interlock signal from a parts sensor or PLC.
• a level control switch or low current relay contact closure , switching a 5Volt DC 2mA signal.

50 Hz or 60Hz

The 6000 series controllers will operate on either 50 Hz or 60Hz.

AC/DC Operation (Full-Wave / Half-Wave Output)

Choose to operate at either 120 or 60 pulses per second by simply flipping a switch on the board.

A More Linear Output Curve

The microprocessor based controller spreads the power curve across the Main Potentiometer providing more finite control over the feed rate and reduces "touchy" controls.

Model 6000 Series Controllers

• Models 6000.1, 6000.2
• Models 6005.1, 6005.2
• Models 6006.1, 6006.2
• Vibratory Controller Settings
• Models 6045.1, 6045.2